Auxiliary: All Listings 

Read More...

Read More...

Read More...

Read More...

Read More...

The Seletek is a peripheral controller developed by Lunático. This version of the driver allows to control its basic sensors and one or two focuser (three in the Platypus version) connected to the Seletek. You can check all the details about the driver an ...
Read More...

Features INDI SQM driver support Ethernet-enabled SQM-LE and USB. The driver provides basic averaged readings from the unit including sky brightness and temperature. Operation Before establishing connection, set the IP address of the SQM-LE unit i ...
Read More...

Read More...

Features USB_Dewpoint calculates in real time the Dewpoint, thanks to ambiant humidity probe close to your instrument. It also connects to 2 external temperature probes (attached to tube or mirrors) and compares these temperatures to the Dewpoint. If tem ...
Read More...

Features When operating a remote observatory, complete control of the devices rest with the remote INDI servers and drivers. In case of a communication loss, the observatory should be capable of performing a graceful shutdown until communication is esta ...
Read More...

Installation DragonLIGHT is included with libindi. Features The DragonLIGHT is a DC powered flat panel controller to illuminate any 12V light source. Configuration As a network device, you will need to connect the DragonLIGHT to your network. Just co ...
Read More...

 Features The relay controller is an industrial 8-ch relay module controlled via Ethernet port, adopts Modbus RTU/Modbus TCP protocols, supports PoE power supply, also comes with an ABS rail-mount case. Features flash-on, flash-off function, by p ...
Read More...

 Features The INDI GPIO driver uses the libgpiod library to access the system's GPIO interface. It only supports ports labeled as GPIO by the kernel. Both inputs and outputs are On/Off switches. The status of output switches cannot be determined, so ...
Read More...