List Categories and Listings by R
Features
Rainbow Astro RSF is a secondary mirror focuser with a stepper motor. It includes a physical remote controller that can be used without a computer.
Main Control
Please note the range for the RSF focuser is -8000 to +8000 with z ...
Read More...
Installation
RPI Camera Driver currently supports the Raspberry Pi High Quality Camera in full raw mode.
Under Ubuntu, you can install the driver via:
sudo add-apt-repository ppa:mutlaqja/ppa
sudo apt-get update
sudo apt-get install indi-rpicam ...
Read More...
Features
The driver supports capture and gain adjustment. The image returned in FITS format is in Bayer BGGR 16 unsigned raw format. Currently with a fixed size of 4056x3040.
To capture a single-frame image, simply set the desired exposure time in se ...
Read More...
The Raspberry Pi GPIO driver allows you to control up to five GPIO pins on a Raspberry Pi. Typically, each GPIO pin is connected to an opto-isolator circuit or Raspberry Pi hat to control larger voltages and currents.
The driver uses the pigpio library a ...
Read More...
Features
RB Focuser is a budget-friendly telescope electronic focuser with a resolution of 0.7 microns, made to keep up with today's fast optics standard. Depending on the version, it comes with: temperature sensor, Auto home function, BlueTooth conne ...
Read More...
Features
The nFOCUS controller is a small DC focus controller that provides two directions at two speeds with only two buttons using a12V regulated output. Low speed is adjustable pulse width modulated (PWM) drive, providing full voltage torque for low s ...
Read More...
Features
The Seletek Aramadillo and Playtubus controllers support control for focuser, rotator, and filter wheels. Therefore, any stepper motor can be configured to act as a rotator. There is no primary difference between a focuser and a rotator when us ...
Read More...
Features
The nStep controller is a small absolute-position stepper motor controller that can work on a variety of motor configurations. It connects to your PC/StellarMate either via Serial-to-USB cable or WiFi. It supports the following features:
Spe ...
Read More...
Features
The settings of the RoboFocus device are polled and displayed in the corresponding fields. Main Control Tab
Port: Set the name of the RS 232 port. The speed is fixed to 9600 baud.
Temperature: read out of the built in temperature sensor (no ...
Read More...
