Directory: A-Z
Features
Do not use this driver with LX200 Classic telescope as it uses a seperate driver. Even though you can use this driver to control LX200 GPS or LX200 16" telescopes, you won't be able to use the extra features provided by these devices
Operation ...
Read More...
Installation
The INDI Avalon StarGO driver is released as a 3rd party driver and requires INDI Library >= v1.7.5. To install the driver under Ubuntu:
sudo apt-add-repository ppa:mutlaqja/ppa
sudo apt-get update && sudo apt-get install indi- ...
Read More...
INDI AZ-GTi Driver based on EQMod driver and is released as a 3rd party driver and requires INDI Library >= v1.7.5.
Features
This INDI driver interacts with a mount controller using the Skywatcher Protocol through WiFi
Goto/Slew at maximum m ...
Read More...
Features
The driver can control the dome's relative and absolute position and calibrate the dome until it reports a valid azimuth position. The user can setup home and park positions in addition to dome slaving parameters. Furthermore, the user can set u ...
Read More...
Features
The Baader Steeldrive motorfocus allows precise remote operation of the Steeltrack focuser. The transmission is performed by a belt system. You can control the focuser absolute & relative positions. You can set the temperature calibration a ...
Read More...
Features
Beefocused is an Open Source Hardware/ Software Telescope Focuser The goal of the project is to create a high quality DIY focuser that's relatively easy to build and modify. It is fully open sourced.
Beefocused talks to the INDI computer usi ...
Read More...
Features
This INDI paramount driver interacts with Paramount mounts via TheSkyX TCP Server either locally on the same computer or across a network connection. Bisque does not permit a direct control of the mount and so TheSkyX must be started and configu ...
Read More...
INDI Celestron AUX Driver is released with INDI Library >= v1.9.4
BETA driver. Do not use unattended. For Alt-Az mode, you must adjust the PID parameters to achieve good tracking. This driver was not fully tested with an Equatorial mount. Use caution. ...
Read More...
Included with libindi v1.6+.
Features
This driver supports Celestron telescopes using the NexStar protocol. The following models use this protocol:
NexStar GPS
NexStar GPS-SA
NexStar iSeries
NexStar SE Series
NexStar GT
Advanced GT
CGE mo ...
Read More...
Features
The Celestron Nextstar supports all GOTO and sky alignment functions of NexStar Evolution telescopes. In principle it should support any Celestron scope using AUX command set (most of them) with SkyFi wireless module. It was never tested ...
Read More...
Features
The Nightscape driver should support all features of the Alta and Aspen cameras including
USB connection
Temperature setpoint
Hardware binning (vertical only. horizontal binning is implemented in software)
Frame sub-selection
Shutter capt ...
Read More...
Features
Celestron SCT Focuser driver is used to control Celestron Motorized Focuser when connected directly to a computer via USB. This driver should not be used if the focuser is connected directly to the mount. When connected directly to the mount, ...
Read More...
INDI iOptron CEM120 Driver is released as a 3rd party driver and requires INDI Library >= v1.6.5.
Features
This INDI driver is not limited to CEM120 as it supports the following iOptron mounts:
CEM120-EC2 with firmware 20171001 and later
CEM120- ...
Read More...
